Description
| Parameters of Product | Lowboy Trailer |
|---|---|
| Model Type | Full Deck |
| Capacity | 50-Ton GG |
| Rear Deck Height | 41" |
| Lower Deck Height | 24" |
| GN Length | 155" |
| Lower Deck Length | 240" |
| Rear Deck Length (PO) | 190" |
| Rear Deck Length (Design) | 192" |
| Overall Length | 587" |
| Overall Width | 108" |
| Ground Clearance | 8" |
| KingPin Style | 2-Position Removable |
| KingPin Setting | 16" & 28" |
| Swing Clearance | 110" & 98" |
| Fifth Wheel Height | 50" |
| Ride Height | 5-Position |
| Fenders | Diamond Plate Steel Fenders |
| Motor | Yes |
| Flip Box Set Up | No |
| Main Beam Center | 46" |
| Deck Main Beam | 16" |
| Deck Side Rail | 16" |
| Crossmembers | 10" & 4" |
| Outrigger Type | Full Height Removable |
| Front Ramps | Steel 18" x 31" |
| Number of Axles | 3 |
| Axle Spacings | 60" |
| Axle Track | 82.5" |
| ABS | 4S2M |
| Axle 1 | Fixed Type 30/30 ABS |
| Axle 2 | Fixed Type 30/30 ABS |
| Axle 3 | Super Lift Type 30 Non-ABS |
| Axle 4 | None |
| Suspension Type | Spring Ride Suspension-25K |
| Dump Type | No |
| Ride Height Adjuster | No |
| Riser (Transition) Ramp | 35° Rear Bridge Ramp |
| Rear Deck Beam | 14" |
| Rear Well Style | Boom & Bucket Well |
| D-Ring in Tail | 3 |
| Flip Axle Set Up | No |
| Rear Deck Option (Beavertail) | No |
| Wood | Apitong Open Center |
| Wheel Covers | Steel Single Wheel Removable |
| Well Decking | Removable D-Plate Full Length |
| Tire | 255/70R x 22.5" H |
| Rims | Piloted Steel |
| Notes | Strobes to be located on the outside (each side) of the rear bumper per State of Montana's law. - Diamond Steel fenders on GN. Should allow for 8"-9" clearance between fenders and tires, with a short mud flap in the front and a chain hanger set up. - 63’’spacing on first 2 axles, and 60’’ on rear air lift similar to Brochure model 50LB151098 - Mountain Style raised front pullout outriggers - Overall length to be provided once engineering completes design for multiple axle spacing for the tail. -D-rings every 2' Customer sending in schematic for custom bracket hinge to be mounted on rear bumper. Revision 1 - 1 D-ring on each side of gooseneck in front of pony motor lid - 1 D-ring on each side of gooseneck behind pony motor lid - 3/4" Steel plate to cover rear 6' of boom well welded to top flanges of tail - 2 D-rings on rear bumper; set on tail beam centers - Expanded metal 1st and 2nd bays |
Recent Comments